Musical Fidelity A3cr Spécifications télécharger pdf (Page 5)

issue 2/12.10.2000

CONNECTIONS

A3

CR

preamplifier Instructions for Use. Page 5 of 9

Before switching on the stereo system

please read carefully the instructions on the

following pages. The functional arrange-

ment of the controls makes the stereo sys-

tem easy to operate. You should neverthe-

less study these instructions to get the best

from your equipment.

BEFORE YOU SWITCH ON

You should make all connections to the

A3

CR

preamplifier before switching on.

Follow this routine before you listen for

the first time, and each time you change

any connections.

1 Check all the inputs and outputs to

the A3

CR

preamplifier.

2 Then check again.

3 Turn the volume control to

minimum.

4 Now you can switch on the power.

Wait for the power-up mute circuit to

switch off. approx. (15 to 20

seconds) The red LED in the vol-

ume control will now light.

Carefully advance the volume to the

level you want and enjoy the music.

NOTE

If the unit was switched off while

muted by the remote control, it will

still be muted next time it is switched

on. Press MUTE on the remote con-

trol to switch mute off. (LED on is

mute off, LED off is mute on)

For connecting the inputs or the outputs

Musical Fidelity recommend either the

600mm X-LINX signal interconnects or

the highly rated Nu-Vista interconnects

with integral RFI suppression. Various

lengths are available in Nu-Vista intercon-

nect cables.

Please contact your local dealer for more

information

OUTPUT CONNECTIONS

All connections should be made with the

power OFF.

The A3

CR

preamplifier has a right hand

line output and a left hand line output.

Plug the Red phono plug into the right out-

put and the other plug into the left output.

Now connect the other ends to the input of

your power amplifier, red to right input

and the other to the left input.

INPUT CONNECTIONS

All connections should be made with the

power OFF.

The A3

CR

preamplifier has 1 phono input

which can be used for either moving mag-

net (MM) or moving coil (MC) cartridges.

The type of cartridge is selected by the

switch on the back panel of the preamplifi-

er. (See Phono section of this manual for

further information)

The A3

CR

preamplifier also has 5 line

level inputs - CD, Tuner, AUX, SACD,

and Tape.

All line level inputs are electrically identi-

cal and are suitable for use with any source

component with an output voltage in the

hundreds of millivolts (mV). This includes

CD players, SACD players, tuners, tape

machines and the audio outputs of video

recorders, televisions, DVD and LaserDisc

players etc.

1 2 3 4 5 6 7 8 9

Commentaires sur ces manuels

Pas de commentaire